Universal pneumatic paddleshift system for sequential gearboxes, built around a compact central unit with the GCU gearbox control unit, accumulator and valves. Offered as a ready-to-install kit with harness, hosing and brackets, or as a hardware-only kit, each for a cable-operated throttle or an electronic throttle (E-gas).
SKU 01.00.0012X · € 3450.00 ex VAT · Motorsport / Paddleshift kits
At the centre of this paddleshift system sits a compact central unit holding the GCU (gearbox control unit), an 800 cc accumulator, a pressure relief valve, a pressure sensor and the valves for upshift, downshift and throttle blip. The GCU is a stand-alone controller with its own setup software and controls each shift with high precision, so the driver keeps both hands on the wheel and needs neither the clutch nor heel-and-toe to change gear. The system was designed as a universal pneumatic shifting system for sequential gearboxes, and the shift cylinder can be mounted on the gearbox or on the gear lever.
Four versions cover two choices. On cars with an electronic throttle (E-gas) where an electronic blip can be used, the central unit carries two valves and no blip cylinder is needed; with a cable-operated throttle the unit has three valves and an in-line blip cylinder is supplied. The ready-to-install kit adds everything needed to fit the system: Goodridge air hosing with adapters, a wiring harness with Deutsch connectors and DR-25 sleeving with moulded boots, a sandwich plate with four free-to-use buttons, paddles and curly cable, the mounting brackets, and one hour of remote support for the setup. The hardware-only kit is meant for builds that source their own mounting parts. For a setup outside these four versions, KMP technical sales can advise on a custom solution.
| Application | Sequential gearboxes |
|---|---|
| Control unit | GCU, stand-alone |
| Accumulator | 800 cc |
| Valves | 3 (cable throttle), 2 (E-gas) |
| Sandwich plate | 4 free-to-use buttons (ready-to-install kit) |
Ready-to-install kit
Hardware only kit
If the car has an electronic throttle and an electronic blip can be used, choose a version with E-gas. Its central unit has two valves and no blip cylinder is needed.
The ready-to-install kit holds every part needed to install the system, including hosing, wiring harness, sandwich plate with paddles, brackets and one hour of remote setup support. The hardware-only kit holds the central unit, compressor, shift cylinder, two paddles and, on the cable-throttle version, the blip cylinder.
Directly on the gearbox or on the gear lever. Different shift cylinders are available for other installations.