Ten KMP Original push buttons on one CAN line: the PRO-Line CAN-Bus wheel is the plain, high-force version of the universal wheel, without illumination or encoders. Power and CAN on a 4-pin DTM connector, 6 low-side outputs, DBC file supplied; label texts, mapping and CAN speed are agreed with KMP after the order.
SKU 01.06.89110 · € 1625 ex VAT · Motorsport / Wheels
Ten KMP Original push buttons, no illumination and a single CAN line: the PRO-Line CAN-Bus wheel is the plainest way to get a full set of wheel controls into a race car that runs its own ECU, power distribution module or logger. The high-force buttons sit on carbon plates around the KMP centre and are built for gloved hands and rough tracks; the function names are laser-engraved as text labels on the wheel face itself, next to each button, in the customer's wording. Each button has a short press and a long press of 2 seconds, set as momentary, toggle or blink, and six low-side outputs of up to 200 mA switch devices directly from the wheel. Carbon paddles on a 7075 aluminium mechanism come as standard and are left off for a manual gearbox.
Installation is a cable, not a harness: the curly cable ends in a DTM04-4P connector for power and CAN, the DTM06-4S mating connector is supplied, and the wheel speaks 500 kbit or 1 Mbit CAN as described in the DBC file that comes with it. The wheels are built and stocked. After the order a KMP sales engineer confirms the CAN speed, the function of each button and the label texts; KMP loads the configuration and engraves the labels before shipping, and later changes are made with KMP through remote support. The photo shows a PRO-Line with a vehicle layout; the engraved labels and the logo are made to the customer's specification. Finish, adapter, paddles and shift lights are chosen in the configurator.
For off-road and track use only. These products are not road-legal, and KMP accepts no legal responsibility for use on public roads.
| Wheel diameter | 330 mm |
|---|---|
| Total height | 150 mm |
| Controls | 10 buttons |
| CAN interface | 1 x CAN, 500 kbit or 1 Mbit, DBC file supplied |
| CAN ID | 0x7CB (1995) as standard, bitmasking available |
| Digital outputs | 6 x low side, max 200 mA |
| Supply voltage | 8 to 18 V |
| Operating temperature | -20 to 85 °C |
| Connector | DTM04-4P on the wheel, DTM06-4S supplied |
| Bolt pattern | PCD 70 mm, 6 x M5 |
Steering wheel assembly
Additional items
The PRO-Line carries 10 KMP Original high-force buttons without illumination and without rotary encoders, on a carbon-plate face. The Clubsport CAN-Bus wheel has illuminated buttons plus two encoders. CAN interface, outputs, connector and configuration are the same.
Yes, together with KMP. Mapping and firmware are loaded by KMP before shipping and changed later through a remote support session; there is no end-user programming tool. The label texts are engraved on the wheel face at order, so new names mean re-engraving.
The wheel comes with a curly cable ending in a DTM04-4P connector, with the DTM06-4S car-side connector in the box. The adapter is chosen in the configurator: a fixed spacer, a crash hub, or a quick release with the connector integrated in the coupling.