Universal CAN-Bus Wheel – GT4 Carbon

The carbon fibre GT4 wheel as a universal CAN-Bus controller: 8 push buttons on engraved label plates and 2 shift paddles, sending their states over one CAN line with 6 low-side outputs alongside. Power and CAN on a 4-pin DTM connector; label plates, centre logo and mapping are made to the customer’s specification after the order.

SKU 01.06.89200 · € 2550 ex VAT · Motorsport / Wheels

The carbon fibre GT4 wheel that KMP builds for the BMW F-series M cars is also made as a universal CAN-Bus wheel, for a race car with its own ECU, power distribution module or logger. The wheel keeps the GT4 geometry and its 8 push buttons on laser-engraved label plates with the carbon paddles behind them, but the electronics inside speak CAN instead of simulating a factory wheel: every button has a short press and a long press of 2 seconds, set as momentary, toggle or blink, and six low-side outputs of up to 200 mA switch devices straight from the wheel. The photos show the BMW version; the label texts and the centre logo are made to the customer's specification, and the wheel is also ordered without paddles.

The car side needs power and one CAN line on the DTM04-4P connector at the end of the curly cable; the DTM06-4S mating connector is supplied. CAN runs at 500 kbit or 1 Mbit and the messages are described in the DBC file that comes with the wheel, with bitmasking available where needed. After the order a KMP sales engineer confirms the CAN speed, the function of each button, the label texts and the logo; KMP loads the configuration before shipping and makes later changes through remote support. The adapter and the paddles are chosen in the configurator; finish, colours and centre cap are fixed on this wheel and it has no shift-light option.

For off-road and track use only. These products are not road-legal, and KMP accepts no legal responsibility for use on public roads.

Highlights

Technical specifications

Controls8 buttons + 2 shift paddles
MaterialCarbon fibre
CAN interface1 x CAN, 500 kbit or 1 Mbit, DBC file supplied
CAN ID0x7CB (1995) as standard, bitmasking available
Digital outputs6 x low side, max 200 mA
Supply voltage8 to 18 V
Operating temperature-20 to 85 °C
ConnectorDTM04-4P on the wheel, DTM06-4S supplied
Bolt patternPCD 70 mm, 6 x M5

What's in the box

Steering wheel assembly

Additional items

FAQ

Is this the same wheel as the BMW GT4 steering wheel?

Mechanically yes: the same carbon fibre GT4 wheel, buttons and paddles. The electronics are different. The BMW version simulates the factory wheel on the car's own wiring; this version is a CAN node with a DBC file and six outputs, for cars with their own ECU or power distribution module. The BMW logo on the photos is replaced with the customer's logo.

What does the wheel put on the bus?

The state of each of the 8 buttons, in short and long press, and the paddles, as CAN messages at 500 kbit or 1 Mbit under the ID agreed at order (0x7CB as standard). The DBC file describes them for the ECU or logger. The 6 low-side outputs switch devices directly without a CAN interface.

Are shift lights or a paddle-less version available?

The GT4 wheel has no shift-light option. It can be ordered without paddles for a manual gearbox; that and the adapter are the two choices in the configurator. Finish, colours and centre cap are not options on this wheel.

Home · Motorsport