Clubsport wheel as a universal CAN-Bus controller: 10 illuminated laser-engraved buttons and 2 rotary encoders on one CAN line, with 6 low-side outputs for devices that take a direct switch. Power and CAN run through a 4-pin DTM connector; button icons, mapping and CAN speed are agreed with KMP after the order.
SKU 01.06.89004 · € 1500 ex VAT · Motorsport / Wheels
Where a racing wheel has to talk to an ECU, power distribution module or logger instead of a factory harness, the Clubsport CAN-Bus wheel puts the familiar Clubsport switchgear on a single CAN line. The 10 push buttons carry laser-engraved, non-removable OEM-style icons and are illuminated, with the brightness set over CAN or at a fixed percentage. The 2 rotary encoders turn and push for menu, page or map selection. Every button works in two modes, a short press and a long press of 2 seconds, and each function can be set as momentary, toggle or blink. Six low-side outputs of up to 200 mA switch devices directly, so a dash, a drink pump or a radio can hang off the wheel without a CAN interface of its own. Shifts run through carbon paddles on a 7075 aluminium mechanism, or the wheel is ordered without paddles for a manual gearbox.
The car side needs only power and CAN: the curly cable ends in a DTM04-4P connector and the DTM06-4S mating connector is supplied. CAN runs at 500 kbit or 1 Mbit and a DBC file comes with the wheel, with bitmasking available for installations that need it. Wheels are built and stocked; after the order a KMP sales engineer confirms the CAN speed, the button functions and the icons, chosen from the KMP library or supplied by the customer, and KMP loads the configuration before shipping. Later changes are made together with KMP through remote support. The photos show an existing layout; engraving and logo are made to the customer's specification. Finish, adapter, paddles and shift lights are chosen in the configurator.
For off-road and track use only. These products are not road-legal, and KMP accepts no legal responsibility for use on public roads.
| Wheel diameter | 330 mm |
|---|---|
| Total height | 150 mm |
| Controls | 10 buttons + 2 encoders |
| CAN interface | 1 x CAN, 500 kbit or 1 Mbit, DBC file supplied |
| CAN ID | 0x7CB (1995) as standard, bitmasking available |
| Digital outputs | 6 x low side, max 200 mA |
| Supply voltage | 8 to 18 V |
| Operating temperature | -20 to 85 °C |
| Connector | DTM04-4P on the wheel, DTM06-4S supplied |
| Bolt pattern | PCD 70 mm, 6 x M5 |
Steering wheel assembly
Additional items
Power between 8 and 18 V and one CAN line, both on the 4-pin DTM04-4P connector at the end of the curly cable; the DTM06-4S mating connector is in the box. The wheel sends its button and encoder states as CAN messages described in the supplied DBC file. The six low-side outputs are optional and only wired when a device is switched directly from the wheel.
After the order a KMP sales engineer confirms the CAN speed, the function of each button and encoder, the icon set and the illumination mode. KMP loads that configuration and engraves the caps before the wheel ships. Later changes to the mapping or firmware are made together with KMP through remote support; there is no end-user programming tool.
Yes. Paddles are deselected in the configurator for a manual gearbox, and a CAN-Bus shift-light row can be added; it needs minor extra wiring. Finish and adapter are chosen there as well.