Quick release for racing steering wheels with a 13-pin Souriau 8STA Motorsport connector built into the coupling, so the wheel’s signal and power lines connect and disconnect with the wheel itself. Three-point self-centering geometry, zero play without clamping force, one-hand operation, validated beyond 50,000 coupling cycles.
SKU 01.06.00251 · € 575 ex VAT · Adapters / Automotive Electronics / Motorsport / Other
With the KMP Quick release connector the wiring goes through the coupling itself: a 13-pin Souriau 8STA Motorsport connector sits in the centre of the quick release and mates as the wheel is fitted, so the wheel's signal and power lines connect and disconnect with the wheel instead of running through a loose cable across the coupling. Mechanically it is the same coupling as the KMP Quick release: a self-centering design built around a three-point contact geometry, with zero play in all directions and in rotation, achieved geometrically rather than with clamping force. One-hand operation lets the wheel be released and refitted quickly, a requirement in driver-change and extraction scenarios, and endurance testing has exceeded 50,000 coupling cycles.
The quick release connector suits a KMP racing wheel on a race hub without clockspring as well as a self-built wheel. In a self-build it is commonly combined with a curly cable and the QRC spacer (01.06.00206). Six M5 threads on a 70 mm pitch circle diameter (PCD) on one side take the wheel or the hub, and both bolt sets, button head and countersunk, are supplied.
For off-road and track use only. These products are not road-legal, and KMP accepts no legal responsibility for use on public roads.
| Connector | 13-pin Souriau 8STA Motorsport |
|---|---|
| PCD | 70 mm |
| Thread | 6x M5, one side |
| Weight | 330 g |
| Height | 46 mm |
Supplied
The 13-pin Souriau 8STA Motorsport connector routes the wheel's signal and power lines through the coupling, so the wheel can be removed and refitted without unplugging a cable.
Not across the coupling: the connector takes over that connection. In a self-build the quick release connector is commonly combined with a curly cable and the QRC spacer (01.06.00206).
On six M5 threads at 70 mm PCD on one side, the standard KMP racing wheel and hub pattern. The M5x16 button head and M5x12 countersunk bolt sets are supplied.