Aluminium spacer that sits between the steering wheel and the KMP Quick release connector. Twelve wire exits route the button wiring to the connector in the coupling, and the 10 mm height gives the clearance needed to bolt the quick release directly onto the wheel. Machined from 7075, black satin, 70 mm PCD.
SKU 01.06.00206 · € 45 ex VAT · Adapters / Automotive Electronics / Motorsport / Other
A quick release with the connector in the coupling leaves one practical question in a self-built wheel: where the wires from the buttons go. The KMP QRC Spacer answers it. The 10 mm ring sits between the steering wheel and the quick release, and its 12 exits of 5 mm let the button wiring run from the wheel to the connector without being pinched between the two parts. At the same time it provides the clearance needed to mount the quick release directly onto the wheel. The spacer is machined from 7075 aluminium with a black satin finish, 85 mm in diameter on a 70 mm pitch circle diameter (PCD).
It is mainly used with the KMP Quick release connector (01.06.00251), and a self-build with that coupling almost always needs it, but the 70 mm PCD pattern fits other wheels, hubs and quick releases with the same bolt circle as well. On the car side of the same build the KMP Curly cable spacer (01.06.07950) brings the curly cable out behind the quick release. Mounting bolts are not included.
| Material | Aluminium 7075 |
|---|---|
| Finish | Black satin |
| Thickness | 10 mm |
| Diameter | 85 mm |
| PCD | 70 mm |
| Wire exits | 12x 5 mm |
Supplied
In almost every self-built wheel with the KMP Quick release connector: the spacer makes room for the button wiring between the wheel and the coupling and gives the clearance to mount the quick release directly onto the wheel.
No. It is mainly used with the Quick release connector, but the six-bolt 70 mm PCD pattern fits other wheels, hubs and quick releases with the same bolt circle.
No. The spacer is supplied without mounting bolts.